Tumble Belt Blast Machine Q326 With Pulse-jet Dust Collector For Removing Rust
Application
The tumble belt machines can be used to remove sand and rust from cast, forged and welded parts as well as aluminum and other non-ferrous parts. This series is especially effective for hard-to-clean parts, non-fragile parts and non-core castings. These machines are also available in full automation.
Description
Tumble blasting machine with rubber belt is ideal for processing mass-produced parts, which can be tumbled and exposure of all surfaces to the blasting stream, with high cleaning efficiency.
Specification
| Model Spec. | Q326 |
| Productivity(T/h) | 0.6-1.2 |
| Maximum Load (kg) | 200 |
| Maximum Product (kg) | 10 |
| Disc Dia.(mm) | 600 |
| Capacity(m³) | 0.15 |
| Shot Flow(kg/min) | 100 |
| Separate Type | Sieve + Air Wash |
| Air Volume(m³/h) | 2200 |
| Power(kw) | 10.85 |
Parts Introduction
This is a small cleaning equipment, mainly composed by the cabinet, blasting system, abrasive recycle system, dust collector, electrical system and etc.
a. Blasting Cabinet(Longer Serive Time)
Inside the cabinet, there equips with wearing-resistant rubber to carry the products rotate. The shell is protected by special wear-resistant alloy shield mounted on end sides of belt, which is made by high chromium iron casting.
b. TS Blast Wheel (High Efficiency + Longer Service time)
It is key part of shot blasting machine, consists of blades, control cage, wheel disc, impeller, protective linings, wheel house, feeding pipe, special motor and etc.
c. Door (Good Sealing)
It is single swing door hanging with wear-resistant rubber to protect the door and sealing.
d. Elevator + Air Wash Separator
(with advanced design, dust and abrasive can be separated up to 99.5%)
To ensure conveyor belt not slip when machine is working, the pulley was made into a squirrel cage, that increase friction between belt and pulley, reduce the press-tightening force, extend belt service life. While elevator is equipped with a tension device, belt can be tensed by adjusting the upper bolt when it loose.
e. Cartridge Dust Collector(More Easier to Clean)
Pulse-jet Air Clean System
The dust collector has a push button to “pulse” the cartridges with a jet of compressed air between blast cycle to purge the filter. Upgrade option, the part can be programmed in PLC.
f. Electrical Control Panel (More Safty)
Qualified electronic components from famous company, such as Schneider, Chint or other Equivalent brand;
With Emergency Button; Control Voltage 24V;
Interlock System: there is a limit switch above the door, only after the door closed, can the blasting wheel be started.
Before and After
Package
Product Tags:
|
|
Pulse - Jet Dust Collector Shot Blasting Equipment , Alloy Wheel Shot Blasting Machine For Removing Rust Images
|
